Virgin Hair Extensions

brazilian natural straight, dirty blonde ombre

September 4, 2018
16″ Silky Straight #613 100% Human Hair Wigs, brazilian natural straight, African American Lace Front Wigs Natural Color Body Wave Lace Front Wig.

brazilian natural straight Boutique Hair Bow Tutorial

I did starch my ribbon prior to beginning this bow.
Step 1)
Take the ribbon (I’m utilizing 1 1/2″ ribbon in this tutorial) and make the shape shown above, always be sure to maintain the “right side” (ie- printed aspect up in heart). Ensure the long facet of the ribbon is within the again with the longer side of the ribbon hanging right down to the left.

Step 2)
100% Remy Ombre Straight Hair Extensions Two Tone #1B/30 Black To Caramel Blonde 100gConvey the lengthy aspect of the ribbon up over the existing ribbon so that the lengthy aspect of the ribbon is now up and to the proper.

Step 3)
Take the long facet of the ribbon (that is up and to the precise) and produce it back down BEHIND the highest piece of ribbon in the middle of the bow. The long piece will now be hanging down in the direction of the center of the bow.

Step 4)
Take the piece of ribbon that was hanging down in direction of the center/left bottom and produce it to the upper left facet of the bow. This can be an excellent time to make any changes to your bow to make certain all the loops are even.

Step 5) Flip your bow sideways (horizontal) and in the middle carefully fold the bow (see picture above). For wider ribbon you must brazilian natural straight fold it in order that there are three peaks in the middle.

Step 6)
Using your tremendous gauge wire tightly wrap the wire round the center of the bow and twist it on the again facet of the bow and trim off the long items. Press the wire down so it’s not sharp.

Step 7)
Singe one finish of the smaller ribbon (I at all times use a long candle lighter- fray examine is costly and I’ve discovered it to not work as nicely) to forestall fraying and starting on the again of the bow where the wire is tightened and minimize off, glue one end of your small ribbon. Wrap the ribbon around the center of the bow. Trim off excess ribbon and singe once more and glue down on back of ribbon. It’s vital to completely end the bow prior to attaching it to the clip. Particularly for the alligator clips. Some clips are made with the middle ribbon wrapped around all the clip and this causes the clip to not shut fully and the clip won’t stay in as well. This fashion the “seal” on the clip is tight.

Step 8)
Tear off a chunk of the wax paper and fold it over a number of instances. Clip the alligator clip to the wax paper and load the clip (the angled aspect) up with hot glue. And stick your bow to the glue covered clip. Enable the glue to dry completely after which peel away the wax paper that’s within the clip. Trimming away any excess that may be seen from the front of the bow. This could leave a really smooth and even floor contained in the clip so that it’s going to hold the hair! Trim and singe the ends of the ribbon with the lighter… watch out though… simply barely get the end of the ribbon close to the flame… the ribbon will flip black if burnt.

No Comments

Leave a Reply