How To Curl A Wig With Sponge Rollers And A Blow Dryer
We’ve started with a teal, layered wig. Attempt to find wigs which are good and full – you don’t need blank spots in between your ringlets.
Place the wig on a styrafoam block and secure it with t-pins. We like utilizing a camera tripod for a base – it is fully adjustable and might rotate. Right here is what you’ll need:
– wig block
– wig stand (we used a digital camera tripod)
– sponge rollers
– blow dryer
– clip and/or ties to part off hair
Step Two: Sections
Next, pull up all the wig hair, aside from a couple of tracks near the underside. That is the first section you’ll be curling. We wish to separate each part by the monitor traces (as pictured).
Step Three: Roll It Up
Roll a small part of hair onto one of the sponge rollers. Watch out to keep the rolled hair as neat as attainable – the more time you place into rolling the hair properly, the better your ringlets will look if you unroll cute hairstyles for dark brown hair them.
Step Four: Safe It
Every sponge roller has a latch. After you’ve rolled your hair part fully, safe the latch. If the roller doesn’t stay in place, you’ll have to re-roll the hair a bit tighter.
Step 5: Repeat
Continue rolling small sections of hair onto sponge rollers. As you go alongside, attempt to maintain each section and roll as neat as potential.>
Step Six: Add Some Heat
Hold the blowdryer over every roller for about 60 seconds. We don’t recommend heating every roller for longer than 60 seconds. We put the heat setting on heat and airflow setting on high.
Word: When you apply too much heat, you’ll end up with “ratty” trying curls – lots of stray, kicky hairs.
Step Seven: Repeat
Don’t take out the curlers yet! Roll up the remainder of the wig.
Note: If you are taking out the ringlets as you progress up the wig, one in all two things will occur.
1. The heat of the blow dryer will relax the ringlets you’ve already taken out.
2. The air circulation of the blow dryer will agitate the ringlets you’ve already taken out and can make them look messy.
Step Eight: Unroll
Once you’ve rolled and heated your entire wig, go ahead and take away every roller. Try to be gentle as you do that and of course, ensure that the curls have cooled down a bit earlier than removing them.
Step 9: Keep Unrolling
Instead of just pulling the roller out of the hair, try to gently “unwind” the roller. You’ll end up with nicer wanting ringlets.
Step Ten: Ringlets
Now you will have some lovely ringlets! As you may see, there is a big difference in the best way the wig hair seems! Undo the rest of the wig.
Step Eleven: Finished!
We did slightly gentle teasing once we unrolled all of our ringlets, however you get the basic concept. Have enjoyable and be inventive!
Thanks for studying my tutorial! When you have any further questions, don’t hesitate to contact me at:
Disclaimer: If you’ve never executed this before, have some widespread sense and test this out on a wig you don’t mind presumably destroying. Test out a small section of hair earlier than committing to curling an entire wig. Don’t use a blow dryer near bath tubs stuffed with water. Turn off the blow dryer when you’re completed.
Should you cherished this informative article and also you would like to be given more details with regards to weave i implore you to stop by our page.