Boutique Hair Bow Tutorial
I did starch my ribbon prior to starting this bow.
Take the ribbon (I’m utilizing 1 1/2″ ribbon in this tutorial) and make the form shown above, at all times ensure to maintain the “right side” (ie- printed side up in heart). Make sure that the long facet of the ribbon is within the back with the longer aspect of the ribbon hanging all the way down to the left.
Bring the lengthy aspect of the ribbon up over the prevailing ribbon in order that the long facet of the ribbon is now up and to the right.
Take the long aspect of the ribbon (that’s up and to the fitting) and produce it back down BEHIND the highest piece of ribbon in the middle of the bow. The lengthy piece will now be hanging down in direction of the middle of the bow.
Take the piece of ribbon that was hanging down in the direction of the center/left bottom and produce it to the upper left aspect of the bow. This could be a superb time to make any adjustments to your bow to be sure all of the loops are even.
Step 5) Turn your bow sideways (horizontal) and in the center rigorously fold the bow (see picture above). For wider ribbon you must fold it in order that there are three peaks in the center.
Utilizing your advantageous gauge wire tightly wrap the wire round the middle of the bow and twist it on the again aspect of the bow and trim off the lengthy items. Press the wire down so it’s not sharp.
Singe one end of the smaller ribbon (I all the time use a long candle lighter- fray verify is expensive and I’ve discovered it to not work as well) to forestall fraying and beginning on the again of the bow where the wire is tightened and lower off, glue one finish of your small ribbon. Wrap the ribbon round the middle of the bow. Trim off excess ribbon and singe again and glue down on back of ribbon. It’s essential to fully finish the bow previous to attaching it to the clip. Especially for the alligator clips. Some clips are made with the middle ribbon wrapped round your entire clip and this causes the clip to not close entirely and the clip won’t keep in as properly. This way the “seal” on the clip is tight.
Tear off a piece of the wax paper and fold it over several occasions. Clip the alligator clip to the wax paper and cargo the clip (the angled side) up with scorching glue. And stick your bow to the glue coated clip. Enable the glue to dry fully and then peel away the wax paper that is within the clip. medium length african american hairstyles Trimming away any excess that can be seen from the front of the bow. This should depart a really easy and even surface inside the clip so that it’ll hold the hair! Trim and singe the ends of the ribbon with the lighter… watch out though… just barely get the end of the ribbon near the flame… the ribbon will turn black if burnt.