To apply To apply A Hair Piece
The right application of a hair replacement system is very important. If the system isnt properly place the hair wearer may find the system uncomfortable and un-Styleable.
First you will need to have all your products readily at hand and naturally a mirror will be necessary. Ensure that your system in addition to your scalp is completely clean and free from dirt and oil and both your head and system ought to be dry. For the benefit of your skin it is suggested that you apply a skin cleaner to remove any additional oil on the scalp and if available apply a skinny layer of Scalp Prep to protect your scalp after the system is on. If youre wearing a tape on system, wipe the tape tab area with some 99% alcohol to assure there is no such thing as a residue or oil on the tape tab area. Apply your tape, lifting the liner in areas where youre overlapping strips. Once your tape is in place remove the liner. Have your existing hair clean dry and styled then pick up your system holding the front towards you with the back away from you and have the bottom inverted. Inverting the base will keep the hair from getting on the tape. Locate the middle front of you hair line and gently place the front of the system at this point then gently roll the system back into place in your scalp. Check your placement and if your happy with it press the tape onto your scalp. If you find you’re a bit crooked with your placement gently pull the system off going from back to front, readjust the location and repeat the procedure. Once the system is in place style the hair into your existing hair and you need to be ready to go. After a couple of tries this action becomes second nature.
If youre using a full head bond you are probably using an adhesive so your preparation shall be slightly different. Again, it is very important have system, hair and scalp completely clean and free from dirt and oil. It is particularly important to arrange the scalp utilizing a scalp cleaner and scalp prep. The cleaner has an astringent value that will close the pores and the scalp prep will coat the skin on the scalp to keep potential bacteria from making its way into the skin. If youre wearing a skin system, wipe the bottom with 99% alcohol and permit to completely dry. Once the base is dry apply a skinny layer of your adhesive and permit the adhesive to get slightly tacky. Apply a thin layer of adhesive to your scalp and likewise allow the adhesive to get slightly tacky. Once the scalp and base are ready follow the directions above for applying the system. It is very important with a full head bond to do this procedure correctly the first time. As you roll the system back onto bajul imports your scalp press is gently down to eliminate any bubbles or wrinkles. After you have the system on and in place gently press all the system allowing the adhesive on the base and scalp to bond together. If youre doing a full head bond with lace, follow the identical procedure only eliminate putting the adhesive on the base of the system and apply two thin layers of the adhesive to the scalp allowing the primary to dry before applying the second layer and letting the second layer get tacky, then apply the lace system to the head in the identical manner because the skin.
If you loved this write-up and you would like to acquire extra information pertaining to Unprocessed 3 Bundles Virgin Brazilian Curly Weave Human Hair Bundles Deals kindly check out our own page.